Our reproduction products in hard urethane plastic.
Order the hardware below.
Dimensions / Sizes
All measurements from backside of right panel
3 1/16" long
2 3/16" wide @ butt
15/16" vertical straight edge @ top
1 1/8" horizontal straight edge @ top
1 1/2" wide across center of screw hole (parallel to butt)
5/8" from center of pin hole to butt
13/32" from center of pin hole to front edge of grip
Early or first generation traditional "Rampant Eagle" grips. these
are close in size to the C25, but not exact. You may want to furnish a tracing
of your old grips (if you have them) to make sure they will fit.
Note: Oftentimes, the existing escutcheons have fused to the old grips and
cannot be successfully removed to be reused with the new grips. If you can
retrieve the escutcheons (nuts) from your old grips and have the screw, you will
not need to order these new.
|"We are a licensed manufacturer of authentic reproductions in hard plastic of ColtŪ Gun Grips, Buttplates, and Forends. If you don't see what you are looking for, please contact us. Triple K Manufacturing Co. Vintage Gun Grips Division 2222 Commercial St. San Diego, Ca. 92113