Our reproduction grips in hard urethane plastic.
/ Sizes for the H&R .38 Break Top Hammerless Revolver;
back side of right panel (vertical not diagonal)
1/16” wide across center of screw hole
3/32” wide across center of pin hole @ butt
screws for our items are not included. However, we have screws
for most of our items and, if ordered, we will send the appropriate screws.
If we do not have the appropriate screw(s), we will remove the cost from the
order; or, if we are not familiar with the proper screws for the item ordered,
we will contact you."
Note: Oftentimes, the existing escutcheons have fused to the old grips and
cannot be successfully removed to be reused with the new grips. If you can
retrieve the escutcheons (nuts) from your old grips and have the screw, you will
not need to order these new.